EVil Slim Vista Ultimate

You can either Burn the ISO to a DVD or follow the steps below and make a Bootable USB and Install from there

How to Make a Bootable USB
Use the below Method on Your own Risk
I'm not responsible if you screw up!

First of All You need a USB with Capacity of 2 GB or More.

Run CMD.EXE and type the following. Note: This set of commands assumes that the USB flash drive is addressed as "disk 1". you should double check that by doing a list of the disks (type "list disk") before cleaning it. If you have multiple hard drives, like an SDFlash drive or a Multibay drive, you could end up wiping your second drive using this command.

1. diskpart
2. select disk 1
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

Then extract the ISO Using WinRAR and copy paste all the files on the flash drive.
Change your BiOS settings to allow USB Boot and then plug it in.

After the setup reboots the computer unplug the usb atonce, or it will start booting from USB again.
and at that stage you might feel like its stuck but its not just takes sometime be patient.

Size : 1430 MB (14x100+30)

Incase the windows fails to activate try the Crack below

__________________

Always follow forum rules. Do not Spam or be ready to get BaNnEd.

Much thanks. Ive downloaded a couple of suposedly "registered" versions but they only run a couple of weeks before they start asking you to register. I hope this works better.